Propeller tube installed

I made a new propeller shaft tube out of plumbing pipe and fibreglass, I cast the threaded ends using the original brass fittings as moulds. The tube needed to be changed as the former steel tube was causing electrolysis.

Tube installed in boat

inside view of tube

thread detail

Aaron finished off the battery compartment and Ev finished the paining and installed electric conduit in the bedroom

Comments

Action Shorts - made for paraplegics on the go!

I've been a paraplegic for 43 years and have spent many years sailing the east coast of Australia. I leave the wheelchair hanging off the stern rail and climb and crawl across the boat. Its hard work and pretty hard on the backside too. To prevent injuries from hot surfaces, pressure and scrapes I have developed a pair of shorts that mimic the cushioning that regular sailors have in their backside when sitting down. I call them Action shorts. Here I am in Ballina in 1995 coming back from the Solomon Islands on my sloop MoonPenny. I am wearing my Action shorts with a Roho Nexus cushion inside The shorts are made from neoprene and have to full length zips along the front of each thigh all the way to the waist. This allows you to sit on the shorts and zip yourself in. Inside the shorts, in the area which takes the pressure, I have a Roho Adaptor Pad which is an air cushion that can be cut into different shapes. On my latest pair I have a cummerbund fasted by Velcro. The...

Trip to Yarra Bay

With lockdown ending today we took the boat across Botany Bay to Yarra Bay and spent the night. It was good practice at anchoring storing the dinghy and cooking. We were joined by my son and his mates who swam out and used the boat as a diving platform Ev cooked a delicious eggplant dish for dinner. Sleeping I found difficult as there was beach party that went all night, they were still there in the morning, amazing stamina terrible singing. It was a glorious sunset that went on forever

Installing sound proofing

Finally got around to adding sound dampening foam around the engine box and it made a big difference. Its a 3cm thick foam with a layer of bitumen in the middle which absorb the sound produced by the engine. Its self adhesive and just requires cutting to size and taping the edges to stop fluid getting into the foam It was very reflective in the sun C utting the sheets to size using a sharp box cutter

Whats been happening

Search This Blog